EFIDynoTuning Forum

Is there a source for EEC-IV 60 pin female (can we still say that?) terminals. I had a pretty good stock before RJM disappeared but after a couple of custom harnesses my supply is about dry.

I looked last year for some when I was doing my electric fan install and could not find any, all I found where ones that where either too big or too small. I actually bought them and physically tried them, but no dice. In the end I found someone that was selling an EEC-IV connector with the wires still attached and wound up using some of those for my fan and T4M0 conversion. But if anyone knows of a source I would not mind buying some just to have in my toolbox.

thats what I do I jack them from a junk harness

Me too since I ran out of my supply of RJM's stuff. Thought I had found gold at Terminal Supply where I get a lot of my harness stuff but no Joy. On my swap from A9M to CBAZA I did a complete re-pin out. Unfortunately I ran into brittle terminal lock trouble and just about painted myself into a major corner. At that point I interposed Delphi connectors after the EEC connector and did my pin-out swap through them. Now I can change it back or whatever without worrying about broken terminal locks. Probably not a bad idea to grab any naked 60 pin connectors you might find...even at the stupid price. They won't be available for ever.

I've got a couple of terminal locks that are broken. Other than super glue, and ingenious ways to fix them?

These are for the EEC-IV 60 pin plug.
Male terminals:
https://www.clipsandfasteners.com/Wedge ... a14887.htm

Female terminals:
https://www.clipsandfasteners.com/Wedge ... a14888.htm

The EEC-V plug is smaller diameter. The same company sells both.

Regards,
Daniel

danielt wrote: ↑2021 Mar 16, 23:14 These are for the EEC-IV 60 pin plug.
Male terminals:
https://www.clipsandfasteners.com/Wedge ... a14887.htm

Female terminals:
https://www.clipsandfasteners.com/Wedge ... a14888.htm

The EEC-V plug is smaller diameter. The same company sells both.

Regards,
Daniel

Those are the .110 pins, not the .060.

EEC-V uses an 0.040 size pin IIRC.

I believe EEC-V uses the 0.060 pins. I ordered those first and they were too small.

For the EEC-IV the 0.060 pins are too small and the 0.110 pins are too big. We are in a Goldilocks situation here.

The manufacturer stopped making the ones you looking for. This information was posted on the old forums but it appears that information was lost with the conversion to this new forum. They have been discontinued for like 6 years now