EFIDynoTuning Forum

thats cuz theres a newer patch in the tune than in the xdf

it should have logged perfectly all you had to do is click the button

ok i will load it again.
thank you

just confirming that the A!C is 8061 processor ??

the HWAD3 (auto) and HWMC2 (manual) are 8065 processors.
i am slowly sorting out the tune and will post it soon .

these are the TI Performance base files.
i dont think i changed them.
6dbd.bin goes with HWAD3


think i worked out how to attach as my computer skills are just above clicking a mouse hahaha.

Jamie from oz wrote: ↑2022 Aug 14, 17:35 just confirming that the A!C is 8061 processor ??

yes a1c is eec-iv 8061 ecu from 80s to 90s

decipha wrote: ↑2022 Aug 16, 09:00 yes a1c is eec-iv 8061 ecu from 80s to 90s

This will be why his A1c_aussie_test bins will not data log on our 60 pin eec-v 8065 .

wasnt sure if he had done some hack to be able to try it on our ecu.

yeah it shouldn't even execute

decipha wrote: ↑2022 Aug 17, 07:50 yeah it shouldn't even execute

The 8065 uP will run 8061 software no problem, backwards compatible correct?

I'm going to go a different route with this.
The 6dbd.bin, is speed density and runs on 8065 correct?
My 351w is speed density, so...I'll take my EEC-V 104 pin and run the 6dbd single bank software on it.
Be intersting if it works, then the repinning, etc. etc.

No, for starters the 8061 stack SFR address is different to 8065.