EFIDynoTuning Forum

Decipha, since I don't fully understand, how close to correct should I expect your T4M2, FN1036A table values to be for my 95 Cobra, with bolt ons, PRLDSW set to 0, and FN035 dialed in?

When setting the T4M0 PRLDSW switch to 0 instead of 2, does that make the stock T4M0, FN1036A table values incorrect?

not very

prldsw is irrelevant

fn035 has no bearing either

nope. Failed load only had one correct value

the totldst in histogram automatically givws you the corrections

not very

prldsw is irrelevant

fn035 has no bearing either

nope. Failed load only had one correct value

the totldst in histogram automatically givws you the corrections

Thanks, I'm just learning TunerPro logging setup. So, is this what I need to do in this case?......... set up my RPM columns and TP-REL rows, then log N_TP_TOTLDSTerr in TunerPro?

its already setup you just simply apply the correction it gives you