perload switch A9L2 ?
Posted: 2022 Jun 20, 19:35
I've been away from this for a while and can't remember if I'm using the correct perload switch setting in A9L2 (see image):
the parameter comments say
"PRLDSW - used for determining the value of load%.
Set for load% = load
Clear for load % = load/peak load"
Does 'set for load% = load" mean check the box beside the word 'Set', then hit 'save'?
I know this is a question I've read here before, but searching doesn't yield the results to my question.
I checked all my old tunes and it appears I've never checked the box. I don't remember why I left it that way and can't find any answers searching!?
Thanks for helping me confirm I've got it set correctly.
Sean
the parameter comments say
"PRLDSW - used for determining the value of load%.
Set for load% = load
Clear for load % = load/peak load"
Does 'set for load% = load" mean check the box beside the word 'Set', then hit 'save'?
I know this is a question I've read here before, but searching doesn't yield the results to my question.
I checked all my old tunes and it appears I've never checked the box. I don't remember why I left it that way and can't find any answers searching!?
Thanks for helping me confirm I've got it set correctly.
Sean