EFIDynoTuning Forum

Hope all has a good thanksgiving.

Christmas is around the corner. If anyone has any christmas wishes for the tuning world speak up.

I wish for Christmas that I receive the Edelbrock 60399 head I ordered in November 2020!!
One received last year, one on back order. Currently they tell me will be shipped Dec. 3rd 2021.

How about a tutorial an on how to convert a 224k 1-8-0-9 to a 256K 0-1-8-9 and back again?

I did that years ago its in the disassembly write up step by step

Yes sir. I have been reading it for the last few days over and over. I am not fully understanding each step I guess and am ending up with a file size to large. There was another post last week of another guy running into the same issue as I am. About the only thing I have been successful at is able to identify where the banks are and the order they are in for the bin I am looking at. Maybe what I should have asked for is more detailed explanation for each step.

i think yall missed the note at the top

Most hex editing software like HHD's Hex Editor will not let you cut and insert paste instead paste overwrites so you have to do this as detailed.

if your larger than 256k then your not cutting and instead are copying

I am gonna start a post on this so it can be discussed in detail. I don't distract from your question about a Christmas present to the tuning community.



thank you