Can anyone tell me about OLMTD1 (OL fuel mult. time delay)?

Vehicle specific forum for tuning the Foxbody Chassis Mustangs utilizing the LUX0, GUFA, GUFB, and GUF1 Strategy

Can anyone tell me about OLMTD1 (OL fuel mult. time delay)?

Unread postby scott88 » Wed Jul 11, 2018 3:53 pm

I have a value of 38 sec for this scalar (using BE, tune based off an A9P calibration /strategy) I believe this is the stock setting for this as I have never altered it, but I am curious as I try to learn more about the scalars in my tune, what this exactly does. Any info you can share is MUCH appreciated! I should add that I am in forced open loop at all times.
Scott
scott88
General Poster
 
Posts: 7
Joined: Wed Jul 31, 2013 1:20 pm
Vehicle Information: 1988 Mustang coupe
306/Vortech SC 9lbs/AFR 185 heads/60lb injectors/ProM 80mm/etc, etc
Tuned with Moates QH & Binary Editor based off A9P ECU

Re: Can anyone tell me about OLMTD1 (OL fuel mult. time dela

Unread postby JBasham » Fri Jul 13, 2018 2:15 pm

All I remember is Michael suggested all the open loop delay scalars are not important and they can be set to 0 so the other open loop triggers I set, like the throttle position OL trigger, will work to switch on and off directly like I set them up.
JBasham
General Poster
 
Posts: 13
Joined: Sun May 20, 2018 7:58 am
Vehicle Information: 1991 Ford Mustang 5.0 motor; A3M1 ECU GUFB A9L2; Quarterhorse and TunerProRT


Return to Foxbody Tuning

Who is online

Users browsing this forum: No registered users and 2 guests