EFIDynoTuning Forum

Is the following correct when looking at the position of the 36-1 wheel and crank keyway.
I'm comparing this to a 351w setup I have.
- crank keyway is at TDC, around 30 degrees
- crank sensor pointed directly over tooth, 90 degrees mounting location
- missing tooth exactly 5 teeth away

Image was done in ms paint, not precise and I think it gets the idea accross.

Yes, at tdc the sensor needs to align with the 5th tooth

on the homepage under reference very bottom is the ignition write up that has a pictogram.

http://www.efidynotuning.com/ignition.htm