Page 70 of 71
Re: EEC V file conversion
Posted: 2025 Apr 29, 14:53
by jsa
Ultracompare is my goto for compare and merge.
V4.14.2 does the duplicate warning in msg. May as well run it on your other DIR too.
Re: EEC V file conversion
Posted: 2025 May 01, 12:32
by BOOSTEDEVERYTHING
I’ll have to try and sit down this weekend and get them sorted out a bit. Not sure what happened. May have had the usb drive disconnect while saving or something and corrupted the file or something. It may take me a while to compare them and merge them together correctly.
Re: EEC V file conversion
Posted: 2026 Aug 26, 13:59
by BOOSTEDEVERYTHING
I am to a point where I would like to add some things to the READ0 xdf file but am a bit confused as to exactly what goes where when entering the values. Or making a spreadsheet to import into BE or TunerPro. Does someone have a start to a spreadsheet that I could use to start the process or use as a template? I know it has been a while but work actually got busy and so did life but want to get back on this project.
Re: EEC V file conversion
Posted: 2026 Aug 26, 17:51
by Jamie from oz
I find a xdf or xlsx that is close to the vehicle configuration and modify that .
Re: EEC V file conversion
Posted: 2026 Aug 27, 05:44
by jsa
Jamie's right.
I could dig up a 4 bank blank xlsx for BE if you wanted to go that way.
Re: EEC V file conversion
Posted: 2026 Aug 27, 22:18
by decipha
last i known BE doesnt allow those
If your doing any development at all tunerpro is definitely easier and far superior as you can edit it in realtime. BE had to reload everytime the xls changed.
Re: EEC V file conversion
Posted: 2026 Sep 02, 15:12
by BOOSTEDEVERYTHING
Ok, do you have a spreadsheet started at all for the READ0 xdf or did you just enter in a few things into TunerPro? Thanks
Or can TunerPro export a spreadsheet file from an xdf?
Re: EEC V file conversion
Posted: 2026 Sep 02, 15:14
by BOOSTEDEVERYTHING
Jamie from oz wrote: ↑2026 Aug 26, 17:51
I find a xdf or xlsx that is close to the vehicle configuration and modify that .
Not sure what would be close to an Explorer PCM, maybe an SN95 Mustang?
Re: EEC V file conversion
Posted: 2026 Sep 02, 17:33
by Jamie from oz
I have a Australian 4 bank xlsx that I can strip a couple things out and post that if you need ( AU 2000 falcon ) and think there might be one posted in the eectuning forum)
Re: EEC V file conversion
Posted: 2026 Sep 07, 02:22
by jsa
There are a number of multibank XDF's on this site that could be used as a baseline to edit into READ0.
There are a couple of BE xlsx definitions on eecanalyzer for two bank bins, that could be used as a starting point for for your 4 Bank READ0.
http://www.eecanalyzer.net/index.php/co ... DPFwfZP1wi
http://www.eecanalyzer.net/index.php/co ... Bn1_pkc-1g,,