Rpm's climbing when put into gear

[Squinks]

I am attaching my data log and tune for reference. The truck idles perfect "Blip the throttle rpms come down smoothly" and also drives down the street if you got a clear shot ahead...
Issue is...When I put the vehicle into gear the RPMs shoot up and the truck wants to take off immediately. If I let it accelerate without fighting it the truck will climb up to around 8mph then the rpms decay. The truck will repeatedly do this when trying to sit at a complete stop. I have tried everything to my knowledge of a 2 week binge on Decipha's Write up's, tweaking Dashpot Tables to no avail.
MAF curve is from the flow sheet provided with MAF (Added +5% @ Idle)
Injector Slopes are skewed to 39.50 Fuel Pressure (did my best)
I appreciate anyone curious enough of look into this.
Using Binary Editor for tuning/ Do I make the leap to TunerPro?
Link to Datalog & Tune:
https://www.dropbox.com/scl/fo/11lv0kzn ... imi3e&dl=0

Thanks,

[Squinks]

Been messing around with the ISC drive multiplier. Am I just not shooting low enough values into that table?

[Squinks]

Looking further into the tune this morning. Im positive I have some functions in here I have set wrong. Give me time, Give me time I wanna figure this out and not have a hand held to the finish line.

[Squinks]

Starting from the top. I will keep you updated. Really want to figure this out without needing a hand.
Thanks,

[decipha]

air spark and fuel

see which one spikes when you put it in gear

[Squinks]

Spike in air,
Tinkering around some more with the tune and doing more research now.

[Squinks]

TP is shooting from .98 to 1.05 when puting vehicle into drive. Failing TPS? Might as well go grab one.

[red5.0fogger]

wiggle the wires to the tps while watching the value. Then do farther down the harness as needed. You may have wiring problem or missing ground wires.

[Squinks]

Got it all handled! New tps. New Throttle Cable. Voltage is steady when at idle. Time to datalog!