1999 f150 read &write

Specifics pertaining to the DEC

1999 f150 read &write

Unread postby gj187222 » Sat Mar 23, 2019 8:01 pm

i would like to know what software and hardware i need to get a 1999 f150 ecu to run efi and coil near plug on a sbf with a 4r70w.
gj187222
User
 
Posts: 2
Joined: Sat Mar 23, 2019 7:48 pm
Name: gregg
Vehicle Information: wrecked 2007 mustang gt 5 speed
Vehicle 2 Information: 1999 f150 5.4 auto
Vehicle 3 Information: 1966 f100 289 with aod the engine was build by me in 1986 wornout 4 water pumps 3 fuel pumps 1 starter and a dist. and 1 c4 in 280000 miles. also had to replace head gaskets at 148000 miles. engine still runs good but has a lot of blow by. wanting to rebuild it adding comp 274 roller cam,roller rockers with screw in studs, and efi a 4r70w using what i can from the above like the ecu sensors wires ect.
Additional Vehicles: 1965 mustang gt a code 4 speed

Re: 1999 f150 read &write

Unread postby decipha » Sat Mar 23, 2019 8:41 pm

moates quarterhorse and tunerpro

depending on the ecu you have it will be either fbgi0 which was mostly the 01 and up ecu's or cvaf1 for the older ecu's

you have to configure it correctly for your setup see the eec-v swap link on the homepage
User avatar
decipha
Tooner
 
Posts: 16433
Joined: Mon Jul 15, 2013 5:29 pm
Location: New Orleans, LA
Name: Michael Ponthieux
Vehicle Information: Supercoupin' x10
90 (4x 5spds) - Dante, Ruby, Daja, Ava
91 4r70w - Skarlett
92 (2x) 5spd & auto - Bianqa, Andrea
93 auto - Danika
94 5spd Rionda
95 auto Aisha
Vehicle 2 Information: Others:
00 Lincoln LS - Luanda
98 Camaro SS - Bounquisha
02 Harley F-150 - Sasasha
03 Marauder - DyShyKy
00 Explorer 5L - Bernyce
07 GMC 2500HD 6L - Veranafer

Re: 1999 f150 read &write

Unread postby gj187222 » Sun Mar 24, 2019 7:03 pm

thank you very much i will be getting those . thanks again.
gj187222
User
 
Posts: 2
Joined: Sat Mar 23, 2019 7:48 pm
Name: gregg
Vehicle Information: wrecked 2007 mustang gt 5 speed
Vehicle 2 Information: 1999 f150 5.4 auto
Vehicle 3 Information: 1966 f100 289 with aod the engine was build by me in 1986 wornout 4 water pumps 3 fuel pumps 1 starter and a dist. and 1 c4 in 280000 miles. also had to replace head gaskets at 148000 miles. engine still runs good but has a lot of blow by. wanting to rebuild it adding comp 274 roller cam,roller rockers with screw in studs, and efi a 4r70w using what i can from the above like the ecu sensors wires ect.
Additional Vehicles: 1965 mustang gt a code 4 speed


Return to Dynamic Efficiency Cognitive

Who is online

Users browsing this forum: No registered users and 1 guest