HPX maf 4 inch tube
-
- Posts: 468
- Joined: 2021 Mar 21, 15:17
- Location: Colorado Springs, CO
- Vehicle Information: 95 Mustang GT, CBAZA Quarterhorse
331, 190 11R heads, Edelbrock Victor 50 manifold, F303, T5, 76mm Turbo, 91 octane, Returnless dual pump 03 cobra tank, Behind bars rails, 80# siemens injectors
wbo2_030MtxL
57 F100, RZASA, 04 Crown Vic ecu and harness, 302, GT40 heads, 4r70w, 80# deka5 shorties, Holley carb style throttle body, Speedmaster high rise intake manifold
HPX maf 4 inch tube
Anyone have experience with an standard HPX slot maf in a 4 inch tube? Wondering how stable the signal will be.
-
- Posts: 5033
- Joined: 2021 Feb 15, 12:23
- Location: Metairie, LA
- Vehicle Information: Work Truck
'19 F-150 3.3L
Re: HPX maf 4 inch tube
The sensor element itself has no bearing on the airflow through the housing so it will be as stable as any other sensor element.
-
- Posts: 468
- Joined: 2021 Mar 21, 15:17
- Location: Colorado Springs, CO
- Vehicle Information: 95 Mustang GT, CBAZA Quarterhorse
331, 190 11R heads, Edelbrock Victor 50 manifold, F303, T5, 76mm Turbo, 91 octane, Returnless dual pump 03 cobra tank, Behind bars rails, 80# siemens injectors
wbo2_030MtxL
57 F100, RZASA, 04 Crown Vic ecu and harness, 302, GT40 heads, 4r70w, 80# deka5 shorties, Holley carb style throttle body, Speedmaster high rise intake manifold
Re: HPX maf 4 inch tube
But when you increase the MAF diameter the MAF element can have trouble picking up a signal reliably. You haven't had any issues?
-
- Posts: 5033
- Joined: 2021 Feb 15, 12:23
- Location: Metairie, LA
- Vehicle Information: Work Truck
'19 F-150 3.3L
Re: HPX maf 4 inch tube
no the slot picks up from the center of the pipe not the outside wall so its far less affected