Processing an EEC-V bin file through SAD

All hardware related, disassembly / programming and code discussions belong here.
ATPCR
Posts: 148
Joined: 2023 Feb 18, 22:25
Location: Hazel Green Alabama USA
Vehicle Information: 1997 Mountaineer 5.0 that originally had a wasted spark ignition system. I'm converting to coil-near-plug. I will use a 4.6 Luxury Sedan PCM & modified powertrain harness. It will be reprogrammed to operate the Windsor 5.0.

Processing an EEC-V bin file through SAD

Unread post by ATPCR »

2 months ago, I successfully created an _lst file with SAD. Now when I do it, it looks like a bin file name. What am I doing wrong?
Copy this image that I captured and circle the spot where I need to drop and drag the bin file.
Also, when using SAD, should I start with a 256k 0-1-8-9 bin file?
Tvrfan SAD.PNG
ATPCR
Posts: 148
Joined: 2023 Feb 18, 22:25
Location: Hazel Green Alabama USA
Vehicle Information: 1997 Mountaineer 5.0 that originally had a wasted spark ignition system. I'm converting to coil-near-plug. I will use a 4.6 Luxury Sedan PCM & modified powertrain harness. It will be reprogrammed to operate the Windsor 5.0.

Re: Processing an EEC-V bin file through SAD

Unread post by ATPCR »

A second question would be, If I'm looking to turn off the rear o2 sensors because the catalytic converters are removed, Is this strictly because I'm trying to prevent the PCM from throwing a code and turning on the check engine light or is it deeper than that? like preventing the PCM from switching to open loop mode which and tell me if I'm wrong, or "limp" mode?
After sleeping on it last night, I wonder if I'm actually putting the bin file in SAD correctly, but it is as simple as not labelling the new file correctly?
jsa
Posts: 260
Joined: 2021 Feb 16, 15:46
Location: Australia
Vehicle Information: 95 Escort RS Cosworth
2.0 YBP
CARD / QUIK / COSY / ANTI
GHAJ0
SMD-190 / SMD-490 EEC-IV

Binary Editor
ForDiag

Re: Processing an EEC-V bin file through SAD

Unread post by jsa »

You need to download SAD to your computer, then drop the bin on the local copy of SAD.

That screenshot is on the website GITHUB.
ATPCR
Posts: 148
Joined: 2023 Feb 18, 22:25
Location: Hazel Green Alabama USA
Vehicle Information: 1997 Mountaineer 5.0 that originally had a wasted spark ignition system. I'm converting to coil-near-plug. I will use a 4.6 Luxury Sedan PCM & modified powertrain harness. It will be reprogrammed to operate the Windsor 5.0.

Re: Processing an EEC-V bin file through SAD

Unread post by ATPCR »

OIC. I'm not supposed to go to GitHub to use it, just download it. Thank you for the pointer.
Post Reply